From 234c91693c35191f0098ebf8d23946382ed10876 Mon Sep 17 00:00:00 2001 From: tille <> Date: Thu, 27 Jul 2006 08:05:33 +0000 Subject: [PATCH] typo --- LDP/guide/docbook/Intro-Linux/chap11.xml | 3 +-- LDP/guide/docbook/Intro-Linux/chap2.xml | 2 +- 2 files changed, 2 insertions(+), 3 deletions(-) diff --git a/LDP/guide/docbook/Intro-Linux/chap11.xml b/LDP/guide/docbook/Intro-Linux/chap11.xml index ddab152b..63b783c5 100644 --- a/LDP/guide/docbook/Intro-Linux/chap11.xml +++ b/LDP/guide/docbook/Intro-Linux/chap11.xml @@ -16,8 +16,7 @@ Most likely, your system is already installed with audio drivers and the configuration was done at installation time. Likewise, should you ever need to replace your audio hardware, most systems provide tools that allow easy setup and configuration of the device. Most currently available plug-and-play sound cards should be recognized automatically. If you can hear the samples that are played during configuration, just click OK and everything will be set up for you. -If your card is not detected automatically, you may be presented with a list of sound cards and/or of sound card properties from which to choose. After that, you will have to provide the correct I/O port, IRQ and DMA settings. Information about these settings can be found in your sound card documentation. If you are on a dual boot system with MS Windows, this information can be found in t -he Windows Control Panel as well. +If your card is not detected automatically, you may be presented with a list of sound cards and/or of sound card properties from which to choose. After that, you will have to provide the correct I/O port, IRQ and DMA settings. Information about these settings can be found in your sound card documentation. If you are on a dual boot system with MS Windows, this information can be found in the Windows Control Panel as well. If automatic sound card detection fails If your soundcard is not supported by default, you will need to apply other techniques. These are described in the Linux Sound HOWTO. diff --git a/LDP/guide/docbook/Intro-Linux/chap2.xml b/LDP/guide/docbook/Intro-Linux/chap2.xml index 79e06eba..a5275f83 100644 --- a/LDP/guide/docbook/Intro-Linux/chap2.xml +++ b/LDP/guide/docbook/Intro-Linux/chap2.xml @@ -94,7 +94,7 @@ blast login: _ Logging out is done by entering the logout command, followed by Enter. You are successfully disconnected from the system when you see the login screen again. The power button -While Linux was not meant to be shut off without application of the proper procedures for halting the system, hitting the power button is equivalent to starting those procedures on newer systems. Ihowever, powering off an old system without going through the halting process might cause severe damage! If you want to be sure, always use the Shut down option when you log out from the graphical interface, or, when on the login screen (where you have to give your user name and password) look around for a shutdown button. +While Linux was not meant to be shut off without application of the proper procedures for halting the system, hitting the power button is equivalent to starting those procedures on newer systems. However, powering off an old system without going through the halting process might cause severe damage! If you want to be sure, always use the Shut down option when you log out from the graphical interface, or, when on the login screen (where you have to give your user name and password) look around for a shutdown button. Now that we know how to connect to and disconnect from the system, we're ready for our first commands.